Title page for ETD etd-09222011-101804


Document Type Master's Dissertation
Author Le Roux, Willem Gabriel
Email willemleroux@gmail.com
URN etd-09222011-101804
Document Title Maximum net power output from an integrated design of a small-scale open and direct solar thermal Brayton cycle
Degree MEng
Department Mechanical and Aeronautical Engineering
Supervisor
Advisor Name Title
Prof J P Meyer Co-Supervisor
Dr T Bello-Ochende Supervisor
Keywords
  • Brayton cycle
  • integrated design
  • maximum net power output
Date 2011-09-06
Availability unrestricted
Abstract
The geometry of the receiver and recuperator in a small-scale open and direct recuperative solar thermal Brayton cycle can be optimised in such a way that the system produces maximum net power output. The purpose of this work was to apply the second law of thermodynamics and entropy generation minimisation to optimise these geometries using an optimisation method. The dynamic trajectory optimisation method was used and off-the-shelf micro-turbines and a range of parabolic dish concentrator diameters were considered. A modified cavity receiver was used in the analysis with an assumed cavity wall construction method of either a circular tube or a rectangular channel. A maximum temperature constraint of 1 200 K was set for the receiver surface temperature. A counterflow plate-type recuperator was considered and the recuperator length was constrained to the length of the radius of the concentrator. Systems producing a steady-state net power output of 2 100 kW were analysed. The effect of various conditions, such as wind, receiver inclination and concentrator rim angle on the maximum net power output, and optimum geometry of the system were investigated. Forty-five different micro-turbines and seven concentrator diameters between 6 and 18 metres were considered. Results show the optimum geometries, optimum operating conditions and minimum entropy generation as a function of the system mass flow rate. The optimum receiver tube diameter was relatively large when compared with the receiver size. The optimum counterflow plate-type recuperator channel aspect ratio is a linear function of the optimum system mass flow rate for a constant recuperator height. The optimum recuperator length and optimum NTU are small at small system mass flow rates but increase as the system mass flow rate increases until the length constraint is reached. For the optimised systems with maximum net power output, the solar receiver is the main contributor to the total rate of minimum entropy generation. The contributions from the recuperator, compressor and turbine are next in line. Results show that the irreversibilities were spread throughout the system in such a way that the minimum internal irreversibility rate was almost three times the minimum external irreversibility rate for all optimum system geometries and for different concentrator diameters. For a specific environment and parameters, there exists an optimum receiver and recuperator geometry so that the system can produce maximum net power output.

2011, University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria.

Please cite as follows:

Le Roux, WG 2011, Maximum net power output from an integrated design of a small-scale open and direct solar thermal Brayton cycle, MEng dissertation, University of Pretoria, Pretoria, viewed yymmdd < http://upetd.up.ac.za/thesis/available/etd-09222011-101804/ >

E11/9/126/gm

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  00front.pdf 114.21 Kb 00:00:31 00:00:16 00:00:14 00:00:07 < 00:00:01
  01chapter1-2.pdf 9.83 Mb 00:45:30 00:23:24 00:20:28 00:10:14 00:00:52
  02chapter3-4.pdf 309.19 Kb 00:01:25 00:00:44 00:00:38 00:00:19 00:00:01
  03chapter5-6.pdf 2.17 Mb 00:10:04 00:05:10 00:04:31 00:02:15 00:00:11
  04back.pdf 1.49 Mb 00:06:54 00:03:33 00:03:06 00:01:33 00:00:07

Browse All Available ETDs by ( Author | Department )

If you have more questions or technical problems, please Contact UPeTD.